PangPang ToolsSheet Metal Bend Allowance: Checking sheet-metal bend allowance — Worked Scenario
How do you check checking sheet-metal bend allowance without overlooking a default value or an assumption? Follow the input and result from Sheet Metal Bend Allowance, then review what can change the output before using it.
Tool walkthrough based on an illustrative example; this page is still awaiting an independent content review. Do not treat it as official guidance or a verified regulatory result.
Check the worked example in Sheet Metal Bend Allowance
What this scenario actually checks
Sheet Metal Bend Allowance performs a browser-local calculation using measurements and quantities you control. The results are presented as labelled figures so each number is easy to interpret. The K-factor depends on tooling and alloy; verify dimensions with trial bending.
This walkthrough focuses on checking sheet-metal bend allowance. It follows the published tool inputs, not a new formula or an automatically verified legal, financial, medical or engineering determination.
Start by preparing the right inputs
Enter the following fields using their displayed units: Bend angle (°), Inside radius (mm), Sheet thickness (mm), K-factor. Press Calculate to display the geometric or theoretical results. The K-factor depends on tooling and alloy; verify dimensions with trial bending.
Before copying the example, confirm that each entered unit, date, dimension and default matches your real task. Changing only a visible number without revisiting its assumptions can change what the answer means.
- Enter the following fields using their displayed units: Bend angle (°), Inside radius (mm), Sheet thickness (mm), K-factor.
- Press Calculate to display the geometric or theoretical results. The K-factor depends on tooling and alloy; verify dimensions with trial bending.
- Review material specifications, design constraints and required safety checks separately before procurement or installation.
Worked example with the calculator
Use the following input values: Bend angle (°): 90, Inside radius (mm): 2, Sheet thickness (mm): 1.5, K-factor: 0.4.
The example output is Neutral radius: 2.6 mm. Using these sample input values gives the first labelled output above. The K-factor depends on tooling and alloy; verify dimensions with trial bending.
Treat this as a reproducible example, not a result to reuse with different measurements.
What can change the answer
Review material specifications, design constraints and required safety checks separately before procurement or installation.
Can I use the default numbers for purchasing or safety certification? No. Replace the examples with your real values. The K-factor depends on tooling and alloy; verify dimensions with trial bending.
Before using the result for a real decision
For checking sheet-metal bend allowance, check the original measurements and input units, and save the assumptions alongside any number you share.
Where legal rules, official allowances, equipment ratings or contractual conditions matter, consult their current authoritative documents. An illustrative estimate is not a substitute for that verification.
- Reproduce the example before changing inputs
- Check all units and assumptions, including any default values
- Verify official or manufacturer-specific requirements outside the calculator
Related tools
Use the tools to verify the steps against your own files or text.